Install
Put POLY5 on your FM‑1
The synth and its 24 patches, in one go. Free, from this page, about a minute.
Demo: no FM‑1 is touched, the steps only show what they look like.
- 1 Your browser
- 2 Get ready
- 3 Test connection
- 4 Install
- 5 Done
Checking your browser
- ChromeCan install
- EdgeCan install
- FirefoxCan't install
- SafariCan't install
Next, get your FM‑1 and a USB cable ready.
This browser can't send firmware over USB. Open this page in Chrome or Edge on a computer, and you are a minute away.
Get ready
Tick these off, then we look for your FM‑1.
Looking for your FM‑1
Your browser will ask to use your MIDI devices. Allow it: that is how the firmware reaches the FM‑1.
Ready to install
Do not unplug the FM‑1, and keep this tab open.
POLY5 is on your FM‑1
Play a few keys: every note goes to the next of the five synths. Press GLO for five new sounds, PLAY for the patch's sequence.
Help, if it gets stuck
- Nothing found. Try another USB cable or port, switch the FM‑1 off and on, and close other apps and tabs that use it.
- It stopped while writing. Leave the FM‑1 as it is, plug the cable in again, reload this page and install again: the update carries on.
- The FM‑1 does not start. Switch it off, hold OCT− and switch it on: the USB rescue. Then install again.
- Back to the official firmware at any time with the FM‑1 Firmware Hub.
- Still stuck? Press Copy report under this box and send it to whoever gave you this page, with a photo of the FM‑1's screen. It lists what happened here step by step: nothing personal, and it goes nowhere unless you paste it.
- Coming from another firmware? Saves made with it may be lost. Patches you saved in POLY5 stay when you update POLY5.
Both FM‑1 flash chips are supported; any other chip is refused before anything is erased. The file is checked before it is sent and every block is verified as it is written. Rather a file? POLY5 on GitHub. The installer is Felucca's, by Leo Kuroshita, GPL‑3.0.